Novinka:Altium - nový vývojový nástroj: NanoBoard 3000
(Kategória: Čo by Vás mohlo zaujať)
Zaslal EdizonTN
18.09.2009-10:58



Špecifiakácia:

• Choice of high-capacity FPGAs
  - NanoBoard 3000XN – with fixed Xilinx® Spartan™-3AN device (XC3S1400AN-4FGG676C)
  - NanoBoard 3000AL – with fixed Altera® Cyclone™ III device (EP3C40F780C8N)
  - NanoBoard 3000LC – with fixed LatticeECP2™ device (LFE2-35SE-5FN672C)
  
• Integrated color TFT LCD panel (240x320) with touch screen that facilitates dynamic application interaction
  
• High-quality stereo audio capabilities including: Line in/out/ headphones, audio CODEC with I2S-compatible interface, analog mixer, audio power amplifier and high-quality speakers (located on a separate speaker board attachment)
  
• USB hub, providing connection of up to three USB 2.0 devices, with interfacing handled by an ISP1760 Hi-Speed USB Host Controller
  
• SVGA interface (24-bit, 80MHz)
  
• Variety of standard communications interfaces: RS-232, RS-485, PS/2, 10/100 Fast Ethernet, USB 2.0, S/PDIF, MIDI
  
• Dual SD card readers – for use by user FPGA and Host Controller respectively
  
• IR receiver – supports data transmitted using a 38kHz carrier frequency
  
• Programmable clock (6 to 200MHz) and fixed clock (20MHz) – both available to user FPGA
  
• 4-channel 8-bit ADC, SPI-compatible – providing maximum sample rate of 200ksps
  
• 4-channel 8-bit DAC, SPI-compatible – operating at clock rates of up to 40MHz
  
• 4x isolated IM Relay channels – each channel providing a 5V nonlatching DPDT relay with one coil
  
• 4x PWM power drivers
  
• 8-way general purpose DIP-Switch, 8 RGB LEDs, 5 PDA-style push button switches and a Test/Reset button – all wired directly to the user FPGA
  
• User prototyping area
  
• Dual 18-way (20 pin) I/O expansion headers, with power supply selection links
  
• On-board memories accessible by user FPGA– 256KB x 32-bit common- bus SRAM (1MB), 16M x 32-bit common- bus SDRAM (64MB), 8M x 16-bit common- bus 3.0V Page Mode Flash memory (16MB), dual 256KB x 16-bit independent SRAM (512KB each)
  
• Four 8Mbit SPI flash memory devices – one containing Primary boot image for Host Controller, one containing golden boot image for Host Controller, two for use by user FPGA (for boot/embedded purposes)
  
• SPI Real-Time Clock with 3V battery backup
  
• Accommodates a single plug-in peripheral board for additional system flexibility
  
• Board ID memory – 1-Wire® ID system uniquely identifies the motherboard and any attached Altium peripheral board
  
• Host (NanoTalk) Controller hosts the NanoBoard firmware. Responsibilities include managing JTAG communications (with Altium Designer/User FPGA/connected peripheral board), as well as access to common- bus SPI resources
  
• 5V DC power connector with power switch, plus testpoints for all major supplies on the board (and GND)
  
• High-speed PC interconnection through USB 2.0 allows for fast downloading and debugging

Homepage

Cena: 395,- USD

---

Táto novinka je z mikroZONE
( http://mikrozone.sk/news.php?extend.118 )